Set Up The Router As An Access Point; Set Up An Ipv6 Internet Connection - TP-Link Archer C6 User Manual

Chapter 4
4 4

Set Up the Router as an Access Point

The router can work as an access point, transforming your existing wired network to a
wireless one.
1. Visit http://tplinkwifi.net, and log in with your TP-Link ID or the password you set for
the router.
2. Go to Advanced >
will reboot and switch to Access Point mode.
3. After rebooting, connect the router to your existing wired router via an Ethernet cable.
4. Log in again to the web management page http://tplinkwifi.net, and go to
> Quick Setup.
5. Configure your wireless settings and click Next.
6. Confirm the information and click Save. Now, you can enjoy Wi-Fi.
Tips:
• Functions, such as Parental Controls, QoS and NAT Forwarding, are not supported in the Access Point mode.
• Functions, such as Guest Network, are the same as those in the Router mode.
4 5

Set Up an IPv6 Internet Connection

Set up an IPv6 connection if your ISP provides IPv6 service.
1. Visit http://tplinkwifi.net, and log in with your TP-Link ID or the password you set for
the router.
2. Go to Advanced > IPv6.
Operation Mode, select
Set Up Internet Connection
Access Point and click Save. The router
Advanced
18