Fitting The Batteries; Unico Master And Wall Split Remote Control; Description Of The Remote Control; General Power-On And Management Of Unico Master And Wall Split - Olimpia splendid Unico Twin Instructions For Installation, Use And Maintenance Manual

3
3.2.2

Fitting the batteries

The remote control exclusively requires 2 dry LR03 1.5 V batteries (not included with the supply).
Used batteries should be disposed of solely by depositing them into the appropriate collection points arranged by the Local Authorities
specifically for this type of waste.
Replace both batteries at the same time.
To insert the batteries remove the spring-latch cover on the back of the remote control.
The batteries have to be inserted according to the positive and negative pole markings in the bottom of the battery compartment.
Close the spring-latch cover after inserting the batteries.
3.3

UNICO MASTER AND WALL SPLIT REMOTE CONTROL

The remote control is the interface between the user and the air conditioner. It is therefore particularly important to familiarize
yourself with the parts of the remote control that relate to this interface.
All the references indicated in the following paragraphs refer to figure 52 (unless otherwise specified).
3.3.1 Description of the remote control (fig. 52)
Buttons: used to set or bring up machine functions.
T1 ON/OFF (standby).
T2 Well-being key (automatic)
T3 Night well-being mode.
T4 Operating mode selector.
T5 Fan speed selector.
T6
Button for setting timer and programs.
T7 Button for increasing (+) or decreasing (-) the temperature/time settings.
T8 Button for activating the FREE COOLING air change system (not available in this model).
T9 Movable baffle adjustment On/Off button.
T10 Reset button.
T11 Program start button.
Display: shows the operating state and the values of the settings being carried out.
D1 Fan speed or automatic operating mode indicator (AUTO).
D2 Heating.
D3 Cooling.
D4
Dehumidifier only.
D5 Air change activation (not available in this model).
D6 Night operation switch.
D7 Automatic operation switch.
D8 First operating program switch.
D9 Second operating program switch.
D10 Temperature indicator (thermometer) or time indicator (H/M).
The remote control is also equipped with a sliding cover that can be positioned so as to permit access only to the ON/OFF, Automatic
operating and NIGHT MODE buttons.
3.3.2

General power-on and management of UNICO MASTER and WALL SPLIT

To manage the appliance with the remote control, it will be necessary to have activated the main switch which is included on the
electrical power supply line (the technician that installed the appliance could offer more details regarding the position), or insert
the power plug of the appliance into the socket of the system.
The UNICO machine is fitted with a power switch (fig. 50 ref. A) located below the lower safety guard (fig. 50 ref. B); to run it must
be in "I" position.
Once these operations have been carried out, the machine may be regulated using the remote control.
To transmit commands to the unit, the front of the remote control must be pointed towards the unit's console.
The device emits a beep when it receives a command.
The maximum distance for transmission of commands is about 8 meters.
3.3.3

Turning the unit ON/OFF

Using button T1 it is possible to switch off (stand-by) or switch on the system.
Since the machinÉs control system has a memory, no setting will not be lost when it is turned off.
This button serves to switch the air conditioner on or off for brief periods of time.
In case of prolonged stop of the machine, it must be deactivated turning the main switch off or unplugging the machine
from the mains.
52