MakerBot Replicator 2 User Manual page 25

Hide thumbs Also See for Replicator 2:

Table of Contents

LOADING MAKERBOT PLA FILAMENT

Press the M to Begin Heating the Extruder

A er you've fed the MakerBot PLA Filament

all the way through the guide tube, press

the M button on the LCD menu. The

MakerBot Replicator 2 will start to heat

your extruder.

WARNING: Do not touch the extruder while it is

heating — it heats to 230° C.

Press the M to Continue

A er the extruder reaches 230° C, the LCD

panel will prompt you to load the MakerBot

PLA Filament into the extruder. Click

through the message until your MakerBot

Replicator 2 asks you to press the M when

you see plastic extruding.

MB2020_REP2_UserManual_V4.indd 25

Machines-3D

C STARTUP PROCESS: LEVELING, LOADING, TESTING

CONTINUED

Press the M

7/22/13 5:32 PM

Table of Contents

Troubleshooting

Do you have a question about the Replicator 2 and is the answer not in the manual?