UNPACKING YOUR MAKERBOT REPLICATOR 2
Removing the MakerBot Replicator 2 from the Box
2
2a. Open the plastic covering and firmly grasp
the frame of the MakerBot Replicator 2 from
the outside. Li it out of the box and place it
on a stable surface.
NOTE: The black cable is not a handle. Do not pull
or twist the black cable at any time.
Removing the Accessory Box
3
3a. Remove the two remaining protective
foam pieces from the bottom of the
Replicator 2's box.
3b. Li out the accessory box. This box
contains the remaining items from the
"What's in the Box" section.
NOTE: Your MakerBot Replicator 2 should now be
fully unpacked. We recommend that you keep the
box and foam inserts in case you need to transport
your MakerBot Replicator 2 in the future.
B SETTING UP YOUR MAKERBOT REPLICATOR 2 DESKTOP 3D PRINTER
MB2020_REP2_UserManual_V4.indd 13
Machines-3D
Machines-3D
1
Machines-3D
CONTINUED
13
7/22/13 5:32 PM
Need help?
Do you have a question about the Replicator 2 and is the answer not in the manual?