Table of Contents
Advertisement
Chapter 2. Hardware Setup
Rear View
1
No. Component
1
Power Jack
2
HDMI Out Port
3
HDMI In Port
4
RS-232 Serial Port
5
Auto Switch ON/OFF Enables or disables the next mode. For details, see
6
IR Extension Port
6
2
3
Description
Connects to the power adapter.
Connects to the HDMI In Port on the display device.
Connects to the HDMI Out Port on the source device.
Connects to an RS-232 serial controller, such as a PC or
a control system.
Setting the Switch Mode, page 13
Note: When the Auto Switch is put to ON, the VS481C
will remain in next mode regardless of any RS-232
commands to set the unit into other switch modes.
Connects to an IR Receiver to extend the reception range
for IR signals.
5 6
4
Advertisement
Table of Contents
