Connecting The Vs481C - ATEN VS481C User Manual

Chapter 2. Hardware Setup

Connecting the VS481C

1. Please review the safety information regarding the placement of
this device in Safety Instructions, page 17.
2. Do not power on the VS481C until all the necessary hardware is
connected.
Follow the steps below to connect the VS481C to a source, a compatible ATEN
Video Extender, and other devices as required.
5
1. Use an HDMI cable to connect the HDMI In Port on the display device to
the HDMI Out Port on the VS481C.
2. Use an HDMI cable to connect the HDMI Out Port on the source device to
the HDMI In Port on the VS481C. You can connect up to four HDMI
sources to the VS481C. Three HDMI In Ports are located on the rear panel,
and one on the front.
3. (Optional) To configure the VS481C system settings using RS-232 serial
commands, connect a hardware/software controller to the RS-232 Serial
Port on the VS481C.
8
2
1
4
3