Danfoss VLT FCD 303 Operating Instructions Manual page 98

Initialisation [3] is selected if you wish to use
the unit's factory setting.
Procedure for initialisation:
1. Select Initialisation [3].
2. Disconnect the mains voltage and wait until the
light in the display has disappeared.
3. Connect the mains voltage.
4. An initialisation is performed in all parameters
in all Setups, with the exception of parameters
500 Address, 501 Baudrate, 600-605 Operating
data and 615-617 Fault log.
= factory setting. () = display text [] = value for use in communication via serial communication port
98
®
VLT FCD Series
MG.04.B7.02 - VLT is a registered Danfoss trademark