12.3.2 RINSE THE PROCESSING CYLINDER
Make sure that the mixture treating control panel is in STOP state.
Make sure that the outlet hole is well closed.
Slide out the batch feeder cover and pour approximately 4 inches (10 cm
1 gallon, 4 liters) of water into the cylinder.
close the batch feeder cover.
press the MIXING key.
Let the machine operate for 10 seconds at the most! The appliance is
allowed to run without ice cream mixture for 10 seconds at the
most!
Press the STOP / RESET key.
Place a suitable container under the outlet opening and empty the water
out of the cylinder.
If necessary, repeat procedure until no product residue is visible.
12.3.3 DISSASEMBLE, WASH AND RINSE THE PARTS
Remove the batch feeder cover by pulling it towards you.
Unscrew (in counter-clockwise direction) and remove the
Remove the outlet hole cover
LOCK NUT
55
.