Connecting The Appliance; Instructions For Prevention Of Injuries; Connecting The Appliance To The Water Supply - Valmar EASY 3 TTi Handling, Operating And Maintenance Manual

5 CONNECTING THE APPLIANCE

5.1 INSTRUCTIONS FOR PREVENTION OF INJURIES

When the characteristics of either the water supply or electricity network fail to
meet the requirements for normal operation, the machine must not be
connected to the power supply.
It is forbidden to connect the appliance to the power source when the floor
around the appliance is wet.
It is forbidden to connect the appliance to the power source if any of the side
panels or the cover is missing.

5.2 CONNECTING THE APPLIANCE TO THE WATER SUPPLY


The water supply regulation valve is connected to the WATER SUPPLY PORT.
The water outlet pipe is connected to the WATER OUTLET PORT and to the
outlet pipe leading to the drain. All these terminals have a diameter of 3/4" and
are located on the backside of the machine.
To connect the appliance to the water supply (water supply port) and the outlet
to the drain (water outlet port), use pipes capable of withstanding 1MPa and
measuring at least ½" in diameter (make sure upon the delivery that the pipes
are supplied with the appliance).
WATTER SUPPLY PORT
(condenser)
WATER OUTLET PORT
(condenser)
WATTER SUPPLY PORT (pipe – drinkable water)
If the appliance is meant to be used in areas with two separate water supplies,
two separate water connectors are built in it, one for each: a DRINKING
WATER SUPPLY PORT and a COOLING WATER SUPPLY PORT
(condenser).
The valve belonging to the cooling water supply must not be connected to the
DRINKING WATER SUPPLY PORT.
The valve belonging to the drinking water supply may be connected to the
COOLING WATER SUPPLY PORT and/or to the DRINKING WATER SUPPLY
PORT.
The valve should be opened after the appliance has been connected to the
water supply system.
17