Multicast - Panasonic WV-V6430L Operating Instructions Manual

Parameter
Write Community
Trap Address
Trap Port
Read-only Username
Authentication Type
Authentication Password
Encryption Type
Encryption Password
Read&write Username
Authentication Type
Authentication Password
Encryption Type
Encryption Password

Multicast

7.3.8.
The [Multicast] interface is shown as in Figure 7-31.
Multicast is a transmission mode of data packet. When there is multiple-host to receive the same data
packet, multiple-cast is the best option to reduce the broad width and the CPU load. The source host can
just send out one data to transit. This function also depends on the relationship of the group member and
group of the outer.
Here you can set multicast address and port. You also need to go to Live interface to set the protocol as
Multicast.
It is a string. It is a command between the manage process and the proxy
process. It defined the authentication, access control and the management
relationship between one proxy and one group of the managers. Make sure
the device and the proxy are the same.
The read community will read/write/access all the objects the SNMP
supported in the specified name. The default setup is private.
The destination address of the Trap information from the proxy program of
the device.
The destination port of the Trap information from the proxy program of the
device. It is for the gateway device and the client-end PC in the LAN to
exchange the information. It is a non-protocol connection port. It has no
effect on the network applications. It is a UDP port not TCP port. The value
ranges from 1 to 165535. The default value is 162.
Only when SNMP version is SNMP v3, you shall config this parameter. The
default is public.
Only when SNMP version is SNMP v3, you shall config this parameter. You
can select either MD5 or SHA. The default is MD5.
Only when SNMP version is SNMP v3, you shall config this parameter.
Password requires min of 8 characters.
Only when SNMP version is SNMP v3, you shall config this parameter. The
default is CBC-DES.
Only when SNMP version is SNMP v3, you shall config this parameter.
Password requires min of 8 characters.
Only when SNMP version is SNMP v3, you shall config this parameter. The
default is private.
Only when SNMP version is SNMP v3, you shall config this parameter. You
can select either MD5 or SHA. The default is MD5.
Only when SNMP version is SNMP v3, you shall config this parameter.
Password requires min of 8 characters.
Only when SNMP version is SNMP v3, you shall config this parameter. The
default is CBC-DES.
Only when SNMP version is SNMP v3, you shall config this parameter.
Password requires min of 8 characters.
Function
50