Multicast; 802.1X - Panasonic WV-V1170 Operating Instructions Manual

Multicast

7.3.8.
The [Multicast] interface is shown as in Figure 7-29.
Multicast is a transmission mode of data packet. When there is multiple-host to receive the same data
packet, multiple-cast is the best option to reduce the broad width and the CPU load. The source host can
just send out one data to transit. This function also depends on the relationship of the group member and
group of the outer.
Here you can set multicast address and port. You also need to go to Live interface to set the protocol as
Multicast.
Refer to the following sheet for detailed information.
Parameter
Enable
Multicast Address
Multicast Port

802.1x

7.3.9.
IEEE802.1X works standing for local and metropolitan area networks and port based network access
control protocol. It supports manual operation of the client to choose means of authenticating by which to
control it to access to the Local Area Networks or not. It supports the ability to authenticate, to calculate fee,
to ensure security and to maintain requirements. See Figure 7-30.
Figure 7-29
Select to enable multicast function.
The range of multicast address of Main Stream, Sub Stream1 and Sub
Stream2 is 224.0.0.0 -239.255.255.255.
Multicast port. The range is 1025 - 65534.
Function
50