Network Management Configuration - Zte R800 Handbook

As the factory settings, default 2 website addresses can be detected in public network. When used in private
network, the website address in "server 1"and "server 2"must be modified as the private network supported. Otherwise,
the network condition may be abnormal by the disconnection.
5.3.2. N M
ETWORK ANAGEMENT
The system of R800 LTE Router may achieve remote maintenance and management of the equipment and on-field monitoring
and management of the network status such as viewing the equipment information, upgrade patches, upgrade firmware,
configuration parameters, signal strength, delay and traffic through the built-in platform based on the WMMP Protocol (Wireless
Machine-to-Machine Protocol) and M2M (Machine-to-Machine) platform communications. Specific settings are as follows.
Step 1: Log onto the WEB configuration interface of R800 LTE Router as provided in "5.2.1 Log onto the WEB Configuration
Interface".
Step 2: Click "Application Configuration > M2M Configuration" to open the "M2M Configuration" tab, as shown in Figure
5-3-2.
Step 3: Configure the network management parameters, as shown in Table 5-3-2.
Parameter Meaning
Name
Enable To enable network management by cooperating with our network
management platform.
Server IP address or domain name of the service IP or domain name network
Address management platform server. WORD type, with a Max of 64 bytes. See
the "List of Specifications for A Parameters" for input specifications.
Server Port Port number used by the network management platform server, to be
matched with the server. Value range: 1～65535
Local Port Port used for interaction in connecting the network management
C
ONFIGURATION
Figure 5-3-2 M2M Configuration Tab
Table 5-3-2 Network Management Parameters
30
How to Configure
Press the button to select.
Enable

Disable

R800
HANDBOOK