Installing The Device In The Rack - Brocade Communications Systems X6-4 Hardware Installation Manual

Installing the 8U Chassis Mid-Mount Rack Kit for Two-Post Racks (XBR-DCX4S-0126 and XBR-X64-0126)
3. Remove any existing rack-mount brackets from the device, and install the new Telco mid-mount brackets from the accessory
kit. Refer to the following figure.
NOTE
The following illustration shows mounting brackets from XBR-DCX4S-0126. Mounting brackets from XBR-
X64-0126 kit install the same way.
FIGURE 20 Telco mid-mount brackets installation
1. Telco mid-mount mounting brackets (left and right)

Installing the device in the rack

DANGER
Use safe lifting practices when moving the product.
1. Ensure that the door is removed from the port side of the device, if installed. Refer to procedures for removing and replacing the
device door in this guide.
2. Ensure the device can be oriented so that the nonport side has access to intake air (cool).
3. Use a lift to raise the device to the correct level.
4. If applicable, lock the wheels of the lift.
54
Brocade X6-4 Director Hardware Installation Guide
53-1004106-07