Psion Teklogix Schnellstart- Anleitung 7525 User Manual page 296

Chapter 8: Expansion Modules
Installing A GSM/GPRS Module
• Remove the stylus from the end-cap, and then remove the end-cap at the top
of the WORKABOUT PRO.
• Slide the SW1401 switch to the left to shut off internal battery power.
Important:
With the power shut down, you can install the GSM/GPRS module and the antenna.
• Slide the SIM card into the GSM/GPRS module as shown in Figure 8.6,
with the card oriented printed side up and its notch on the right side.
• Align the GSM/GPRS connector with the expansion connector on the
WORKABOUT PRO. Apply slight pressure to snap the module into place
on the hand-held.
• Settle the SIM Card stopper plate into place with its metal tab inserted into
the SIM Card stopper plate slot on the GSM/GPRS module (for tab and slot
locations see Figure 8.6). Ensure that the scanner flex cable lies on top of
the plate.
• Use the four screws provided to secure the module and SIM Card stopper
plate in place. Tighten the screws to a torque of 2 lbs-in (2 kgf-cm) or until
finger tight
GSM/GPRS
Radio
266
Psion Teklogix WORKABOUT PRO With Windows Mobile 2003 SE User Manual
In order for the WORKABOUT PRO to access the GSM network,
ensure that you slide the SIM (Subscriber Identity Module) card
into the GSM/GPRS module before installing that unit in the
WORKABOUT PRO.
SIM Card
Stopper Plate
SIM Card
Figure 8.6 Inserting The SIM Into The GSM/GPRS Module
SIM Card
Bracket
Slot
GSM/GPRS Module with SIM Card installed
SIM Card Stopper Plate
Tab