Psion Teklogix Schnellstart- Anleitung 7525 User Manual page 294

Chapter 8: Expansion Modules
Installing The PC Card Expansion Module
To insert a PCMCIA PC card in your WORKABOUT, you will need to install a
PCMCIA module equipped with a 100-pin connector. This module snaps onto the
expansion connector on your WORKABOUT PRO.
Important:
• Remove the battery. If your unit is using AC power, disconnect it.
• Remove the end-cap and back plate.
• Slide the SW1401 switch to the left to shut off internal battery power.
• Remove the two screws at the top of the metal frame.
• Align the PCMCIA Card connector with the expansion connector on the
WORKABOUT PRO. Apply slight pressure to snap the module into place
on the hand-held.
• Use four of the screws provided to secure the PCMCIA Card into place
(additional screws have been provided for convenience). Tighten the screws
to a torque of 2 lbs-in (2 kgf-cm), or until finger tight.
Important:
264
Psion Teklogix WORKABOUT PRO With Windows Mobile 2003 SE User Manual
Backup any data in RAM first, since it will be erased when the
unit is turned off.
PCMCIA Expansion Module
Figure 8.4 PCMCIA Module And Mechanical Stopper
Once the PCMCIA module is installed in the unit, you do not
need to remove the back plate to insert a PCMCIA PC card. Just
remove the end-cap and slide the card into the unit.
Mechanical Stopper