Table of Contents
Advertisement
•
Apply gentle downward pressure to securely seat the card in the connector.
•
Align the mechanical stop and use the four screws provided to secure in place.
Tighten the screws to a torque of 2 lbs-in (2 kgf-cm), or until finger-tight.
•
Slide the SW1401 switch to the right to turn power back on.
•
Replace the end-cap.
cm), and replace the
8.1.5 Installing A GSM/GPRS Module
Warning:
The installation of this GSM/GPRS module must be performed
using the appropriate anti-static devices. If unavailable, discharge
static from your body by touching a grounded metallic object
before opening any covers on the unit.
The GSM/GPRS module (model # RA3010) accommodates a GSM radio, a SIM
card (sold separately) and is equipped with a built-in antenna,
mechanical stop for the CF card
your WORKABOUT PRO.
Important:
Backup any data in RAM first, since it will be erased when the
unit is turned off.
•
Remove the battery. If your unit is using AC power, disconnect it.
Psion Teklogix WORKABOUT PRO With Windows Mobile 2003 SE User Manual
Insert the PCMCIA card as
shown here, with the label
facing you.
Figure 8.5 Inserting A PCMCIA Card
Tighten the end-cap screws to a torque of 3 lbs-in (3kgf-
back plate and battery.
. The module snaps onto the expansion connector on
Chapter 8: Expansion Modules
Installing A GSM/GPRS Module
which also acts as a
265
Advertisement
Table of Contents
Troubleshooting
