Change Filter Cartridge; Fill With Oil - EBR 1190RS 2013 Owner's Manual

NOTE
Refer to Table 26 to determine if the oil filter cartridge
needs to be replaced.
6. If replacing the oil filter cartridge, perform the follow-
ing:
A. See figure 49 (Page 113). Remove the two screws to
detach the oil filter cover.
B. Clean the cover and inside the oil filter recess in the
crankcase. Remove any debris.
7. Install both drain plugs after oil is thoroughly drained.
A. Tighten left engine oil drain plug to 18 ft-lbs (25 Nm).
B. Tighten right engine oil drain plug to 11 ft-lbs (15
Nm).
8. Install new oil filter cartridge (Part No. Q1064.1B6), if
removed.
A. Apply a light film of clean engine oil to the rubber
contact surface on the new oil filter cartridge.
B. Push new oil filter cartridge into cover until properly
seated.
C. Install oil filter cover (with filter) onto crankcase with
two screws. Tighten screws to 97 in-lbs (11 Nm).
112
9. Fill oil through filler hole using recommended oil
from Table 20. Always verify proper hot oil level in
sight glass. Do not overfill.
I. Oil capacity with filter change is approximately 3.3
U.S. quarts (3.1 liters).
J. Oil capacity without filter change is approximately
3.0 U.S. quarts (2.8 liters).
10. Install (screw in) fill plug into oil fill hole. Make
sure fill plug is screwed in completely.
NOTE
For ease of installation, apply a light film of clean en-
gine oil to the fill plug o-ring.
Compressed air can pierce the skin and flying debris
from compressed air could cause serious eye injury.
Wear safety glasses when working with compressed
air. Never use your hand to check for air leaks or to
determine air flow rates.