Dip Switches - GiBiDi TAIMEN T6 Instructions For Installation Manual

20
UK
CLOSING SPEED ADJUSTMENT
It's possible to adjust the operator speed to best suit the door type.
Learning procedure:
Ÿ Stop Opener midway between open and close position.
Press and hold Learn Button (Fig.9-1) for 3 seconds.
Ÿ
Light paused single blink .
Ÿ
Rotate the Speed Adjust Pin (Fig.9-6) while opener is running - clockwise to increase speed and anti clockwise
Ÿ
to decrease speed.
Speed may only be adjusted while the operator is traveling between limits.
Ÿ
Adjustment function will close out automatically once either one of the limits has been reached.
Ÿ
If the RUN button (Fig. 9-3) is used to command the operator, the system will automatically execute the three
complete cycles to learn new anti crushing thresholds cause of the new speeds.

DIP SWITCHES

The settings are stored during the rest phase (door closed).
The DEFAULT settings are coloured in grey
DIP Function
DIP 1 8K2 SAFETY EDGE
PHOTOCELLS
DIP 2
AUTOMATIC
DIP 3
CLOSING
Status
8k2 safety edge disabled (terminal N°5).
ON
8k2 safety edge enabled (terminal N°5).
OFF
ON
Photocells enabled, install photocells
Photocells disabled
OFF
Automatic closing disabled.
Automatic closing will work only if photocells are enabled and installed.The
door will close automatically :
ON
Ÿ After 60 seconds the door reached the totally opened position.
Ÿ After 5 seconds subsequently photocells intervention.
Automatic closing disabled.
OFF
Description
(terminal N°4)
.
(terminal N°4)
TAIMEN
.