Related Manuals for GiBiDi BL240
Summary of Contents for GiBiDi BL240
- Page 1 BL240 BL240 - (15400) Operatore elettromeccanico lineare ISTRUZIONI PER L’INSTALLAZIONE Electromechanical linear operator INSTRUCTIONS FOR INSTALLATIONS...
- Page 2 BL240 9 1b BL240 - 24Vdc DESCRIZIONE CAVI / CABLES DETAILS Rosso / Red Positivo / Positive Nero / Black Negativo / Negative Blu / Blue FCA OPEN Marrone / Brown FCA COM Blu / Blue FCC CLOSE Marrone / Brown...
- Page 3 BL240 740 mm 897 mm B ≥ 140 per β = 110° B > 60+d1 per β = 90° D ≥ 90 a1>60 β...
- Page 4 BL240 E=60 100/120...
- Page 5 BL240...
- Page 6 BL240...
- Page 7 BL240...
-
Page 8: Installation Warnings
INTRODUCTION The BL240 operator for swing gates is an electromechanical device that transmits motion to the gate by means of a worm screw. It is locked when the motor is not running, and it is therefore not necessary to install locks for leafs up to 2 m. -
Page 9: Electrical Equipment
BL240 ELECTRICAL EQUIPMENT Electric system setup Set up the electric system as shown (1a - 1b) referring to the electric system regulations and other national regulations in force. Keep the mains power connections clearly separated from the service connections (photocells, sensitive frames, control devices, etc.). -
Page 10: Technical Data
BL240 TECHNICAL DATA Operator BL240 Type Irreversible electromechanical with worm screw Supply voltage 24 Vdc Power absorbed 100 W (~1000 N) Current absorbed 4 A (~1000 N) Electric motor 24 Vdc 3000 rpm Useful travel 320 mm Max thrust/traction force... -
Page 11: Operator Installation
BL240 Table A - for 100 mm column and 50 mm leaf thickness β 90° 90° 100° 110° OPERATOR INSTALLATION Preliminary checks: For proper functioning of the automated device, the existing or new gate structure must meet the following requirements:... -
Page 12: Limit Switch Adjustment
BL240 If the gate is in a material different from iron, make a plate of 5 mm thick with 4 holes. Weld the bracket in the centre of the plate and secure everything with through screws (12). 12- Unlock the operator (see unlocking device). -
Page 13: Final Checks
• That the power cable moves freely; • The gate assembly conforms to EN 12453 and EN 12445; • For further details and information on the reference standards, visit our site: www.gibidi.com MAINTENANCE Periodically check the gate structure, in particular: - Check functioning of the hinges;... - Page 14 Via Abetone Brennero, 177/B, 46025 Poggio Rusco (MN) ITALY Declares that the products: ELECTROMECHANICAL LINEAR OPERATORS BL240 Are in conformity with the following CEE Directives: • EMC Directive 2004/108/CE and subsequent amendments; and that the following harmonised standards have been applied: EN61000-6-1, EN61000-6-3 •...
- Page 15 GI.BI.DI. S.r.l. Via Abetone Brennero, 177/B 46025 Poggio Rusco (MN) - ITALY Tel. +39.0386.52.20.11 Fax +39.0386.52.20.31 E-mail: comm@gibidi.com Numero Verde: 800.290156 w w w . g i b i d i . c o m...