GiBiDi TAIMEN T6 Instructions For Installation Manual page 17

TAIMEN
MOUNT OPENER TO CEILING
Important Note: Do not lift the Opener by the Control Box or damage may occur. Always lift the Opener by the Drive
Ÿ
Rail.
Raise the Opener off the floor and rest it on a Support (Fig.6-1) high enough that the Drive Rail (Fig.6-2) runs
Ÿ
parallel to the ground.
Slide the Drive Rail Hanger (Fig.6-3) along the Drive Rail (up to max 600mm from the Control Box) and align it with
Ÿ
a structural member of the garage.
Securely fasten 2 Metal Hangers (Fig.6-4) to the structural member and then attach the Metal Hangars to the
Ÿ
Drive Rail Hanger.
ATTACH TOWING ARMS
Close the Garage Door and remove the Drive Unit Cover (Fig.7-1)
Ÿ
Insert the Straight Towing Arm (Fig.7a-1) through the slot in the cover.
Ÿ
Attach the Straight Towing Arm to the Drive Unit (Fig.7a-2) using the clevis pin and spring clip provided and then
Ÿ
replace the Cover.
Attach the Bent Towing Arm (Fig.7a-2) to the Towing Bracket (Fig.7a-3) using the clevis pin and spring pin
Ÿ
provided.
Bring the 2 Arms together and align the 2 sets of holes which are furthest apart from each other.
Ÿ
Securely fix the Towing Arms together using the 2 x 8mm screws and nuts provided.
Ÿ
ENGAGING / DISENGAGING
Important Note : Always disengage the Opener with the door in the fully closed position. If disengaging
from any position other than the door fully closed ensure that there are no persons or property near or
directly under the path of the door.
ŸTo Disengage: Pull down on the release handle (Fig.8-1) until a click is "felt" and then release the handle.
ŸTo Engage: Pull down on the release handle (Fig.8-1) once again until a click is "felt" and then release the handle.
CONNECT TO POWER SUPPLY
Connect to a properly earthed power supply using the power cord provided.
Ÿ
Important Note: Ensure that the power cord does not touch the moving door and that no excess cord hangs below
Ÿ
the Opener when it is plugged in.
DOOR TRAVEL ADJUSTMENT
Opening direction:
Loosen the Limit Prong Lock Screw (Fig.10-1) half a turn
Ÿ
Slide the Limit Prong (Fig.10-2) towards the front wall of the garage to increase garage door travel and away
Ÿ
from the front wall to decrease garage door travel.
Retighten the Limit Prong Lock Screw once correctly adjusted.
Ÿ
Closing direction:
Loosen the Limit Prong Lock Screw (Fig.10-3) half a turn
Ÿ
Slide the Limit Prong (Fig.10-4) towards the Control Box to increase garage door travel and away from the
Ÿ
Control Box to decrease travel.
Re-tighten the Limit Prong Lock Screw once correctly adjusted.
Ÿ
17
UK