GiBiDi TAIMEN T6 Instructions For Installation Manual page 19

TAIMEN
TRANSMITTERS DELETING
Following this procedure all previously learned transmitters will be deleted.
Ÿ Press and release LEARN button (Fig.9-1) .
Press for 6 seconds RUN button
Ÿ
Courtesy light will flash and then extinguish.
Ÿ
Deleting completed.
Ÿ
TRAVEL AND ANTI CRUSHING THRESHOLDS LEARNING
During a closing movement Auto Reverse ensures that the garage door will stop and reverse (Safety Reverse) when
it encounters an obstruction thus ensuring the safety of people and property.
During an opening movement the garage door will stop (Safety Stop) when it encounters an obstruction.
The amount of force required to make the garage door Safety Reverse/Stop can be adjusted.
A low force value ensures maximum safety, but requires a very well sprung and installed door in order to avoid
ghosting (false safety reversing/stopping).
The system will automatically compensate on each and every cycle for door wear ageing and seasonal temperature
change for the lifetime of the door.
Learning procedure:
ŸBe sure DIP1 is ON.
ŸPress LEARN button (Fig. 9-1) for 8 seconds.
ŸCourtesy light will flash.
ŸExecute three complete and uninterrupted open-close cycles. If using a transmitter to command the operator, a
transmitter command is required for evey single movement, while if using RUN button (FIG.9-3), the operator
will execute the learning cycles automatically.
ŸDuring Learning, if the door load is excessive, the operator will stop and courtesy light will double flash. The
door requires maintenance.
An automatic re learn will be initiated immediately subsequent to either one of the following occurrences:
Run time deviation becoming excessive.
Ÿ
Safety reverse occurring on 3 consecutive occasions.
Ÿ
During relearn LED (Fig.9-4) will paused single blink then extinguish once relearn is complete.
ANTI CRUSHING THRESHOLDS MANUAL ADJUSTMENT
Once complete the anti crushing thresholds learning process, it's possible to shift the thresholds using the green
adjustment pin OFFSET (Fig.9-5).
Rotate the OFFSET adjustment pin
Rotate the OFFSET adjustment pin counterclockwise to decrease the force required to have an anti crushing
intervention.
(Fig.9-3) .
clockwise to increase the force required to have an anti crushing intervention.
19
UK