GiBiDi TAIMEN T6 Instructions For Installation Manual page 16

16
UK
POSITION AND ASSEMBLY CONTROL UNIT
Control unit can be installed in three different ways (Fig. 1) .
·
method A : Securely attach Socket Piece (Fig.2-1) to the Control Box (Fig.2-2) using the screws (Fig.2-3)
Ÿ
provided.
method B: Do not attach Socket Piece to the Control Box as it will be placed near the drive rail socket (Fig. 1-B).
Ÿ
method C: Do not attach Socket Piece to the Control Box, using the optional axtension kit, it will be placed
Ÿ
anywhere(Fig. 1-C).
DRIVE RAIL ASSEMBLY
Align and insert each Drive Rail Joiner (Fig.3-1) into a Drive Rail Segment (Fig.3-2) and push them together until
Ÿ
they are fully abutted and form one continuous Drive Rail Assembly.
Slide the Drive Rail Hanger (Fig.3-3) onto the Drive Rail Assembly.
Ÿ
Slide the rail sockets (Fig.3-4)
Ÿ
Chain Connector.
Use a 13mm Socket Wrench to tighten the Chain Tensioner Bolt (Fig.3-7) so that the underside of the Bolt Head
Ÿ
aligns with the Indicator Arrow.
MOUNT WALL BRACKET
Determine highest arcing point of the Door and mark this as a Horizontal Line (Fig.4-1) on the wall above the door
Ÿ
Determine the Door center line and mark a Vertical Line (Fig.4-2) on the wall above the door.
Ÿ
Position the Wall Bracket (Fig.4-3) as depicted and ensure its bottom edge is no more than 50mm above the
Ÿ
horizontal marked line (fig.4-1)
Mark the location of the 2 outer most screw holes (Fig4-4)
Ÿ
Fix the Bracket to the wall .
Ÿ
MOUNT TOWING BRACKET
Using two 6mmX50mm self drilling screws, or two 6mmX20mm screws with nuts fix the Towing Bracket (Fig.4-5)
Ÿ
to a structural member of the Garage Door as close to the top edge as possible and on the centerline of the door.
ATTACH DRIVE RAIL TO WALL BRACKET
Important Note: Avoid scratches and potential damage to the plastic covers by placing the Opener on cardboard
Ÿ
(Fig.5-2) .
With the Garage Door (Fig.5-1) in the fully closed position, lay the assembled Opener on the floor in line with the
Ÿ
centerline of the Garage Door so that the Control Box (Fig.5-2) is furthest from the Garage Door.
Raise the Drive Rail (Fig.5-3) up to the Wall Bracket (Fig.5-4) so that the Drive Rail sits in between the ears of the
Ÿ
Wall Bracket.
Align the mounting holes of the Drive Rail and Wall Bracket and fully insert the Long Clevis Pin and secure it with
Ÿ
the Spring Clip.
(Fig.3-6) onto the Drive Rail and then insert the Lock Pin (Fig.3-5) into the Chain and
TAIMEN