4/ System Specifications; 4.1. Component Main Data; Table 1: Component Main Data - Kontron SMARC Eval-Carrier-2 User Manual

4/ System specifications

4.1. Component Main Data

The table below summarizes the features of the motherboard.

Table 1: Component Main Data

SMARC Eval-Carrier-2
Form factor Testing Hardware with 210 mm x 200 mm, max. thickness 3 mm
Memory
EEPROM System The EEPROM type 24LC64 on carrier board connected to SMARC I2C_PM bus.
(U78)
SPI flash socket SPI flash socket (SOIC8 – 1045-8636) with flash memory W25Q128FW
(J48)
EEPROM DDC The EDID EEPROM type 24C04 on carrier board connected to LVDS_I2C bus. Holding display
optional (U72) relevant DDC information. Used by BIOS to initialize LCD. KEAPI support with module.
External I/O
LAN two Gbit-Ethernet ports
USB
two USB 3.0 double stack and one μUSB connector for On The Go (OTG) function: powered
for host, not powered for client. The 5 V output from USB 2.0 and USB OTG is separately
electronically fused to 500 mA. The 5V output from USB 3.0 is electronically fused to 1000
mA each port.
HDMI HDMI connector from SMARC module
DP++ DP++ Display port connector from SMARC module
COM1-4 4x COM RS232, 9-pin DSUB
Camera interfaces Two Camera Header for cameras, including power, GPIO, I2C. Recommended Power should
be 3.3 V, fused with 0.75 A resettable fuse.
Audio Line-in and line-out 3.5mm jack; Front Panel 2x5 Pin Header (2.54mm), supporting both
interfaces I2S and HDA selectable by jumper. On audio header is also Microphone and
Headphone output.
Internal I/O
LVDS
30-pin LVDS dual channel from SMARC module. Configurable 3.3 V / 5V voltage levels of
power for different panels via jumper.
USB 2.0 Header 2.54 mm pitch 2x10-pin USB header with one USB pair
Backlight
Backlight PWM and power. Configurable 12 V/ 5 V voltage levels of backlight power for
different panels via jumper. Maximum Power is 12 W continuous. If the selected panel
exceeds, the provided power by this carrier evaluation of the SMARC module with LVDS can
still be done with external panel power.
eDP eDP connector, shared with LVDS as an option via resistors. PWR Out must provide
+3.3 V +/-10 % with a maximum current of 500 mA and a minimum power capability of
1.5 W.
mSATA 1x slot (full size / half size ; SATA port)
LVDS one LVDS and one LVDS/eDP1.4
PCIe X1 two PCIe 1X slots
mPCIe two card slots (full size / half size) - PCIe & USB; support all MC3 mPCIe cards
SIM Card SIM Card connected to both mPCIe
µSD
microSD card socket from SMARC module
www.kontron.com
SMARC Eval-Carrier-2 – . Rev. 1.1
// 14