Subaru FORESTER Manual page 94

1) Rear lock button
For the rear gate, carry the access key,
close all doors including the rear gate and
press the rear lock button located next to
the license plate light. The rear gate and
all doors will be locked. Also, the hazard
warning flashers will flash once.
NOTE
. If any of the doors or the rear gate is
opened, the doors or the rear gate
cannot be locked.
. When locking, be sure to carry the
access key to prevent locking the
access key in the vehicle.
. After performing the lock operation
using the rear lock button, it is not
possible to unlock the rear gate using
the rear gate opener button for approxi-
mately 3 seconds.
! Interior light interlock function
When the interior light switch is in the door
interlock position, as you enter the operat-
ing range near the driver's seat or the
passenger's seat while carrying the ac-
cess key, the interior light will illuminate for
a limited time period and then turn off.
When the push-button ignition switch is
switched from "ON" to "OFF", or unlocking
is operated by the keyless access function
or the remote keyless entry system, or the
doors are opened/closed, the interior light
will illuminate for a limited time period and
turn off. The interior light will turn off when
any of the following operations is per-
formed.
. When locking is operated by pressing
one of the door lock/unlock buttons
. When the doors are locked by pressing
the " " button on the access key
. When the push-button ignition switch is
switched to "Acc".
When the vehicle is equipped with the
genuine SUBARU navigation system,
enabling/disabling of the interlock and
the time that the light stays illuminated
can be set on the monitor screen. For
details, please refer to the Owner's Man-
ual supplement for the navigation system.
Keys and doors
When the vehicle is not equipped with the
genuine SUBARU navigation system, the
setting can be changed at a SUBARU
dealer. For more details, we recommend
that you contact a SUBARU dealer.
! Door unlock selection function (ex-
cept vehicles with double locking
system)
The door unlock selection function makes
it possible to unlock the driver's door
without unlocking any other doors.
! Unlocking doors with the unlock
function
The operational/non-operational setting
for this function can be changed by a
SUBARU dealer.
Operational: Only the door for which the
door lock/unlock button is pressed will be
unlocked.
Non-operational: All doors and the rear
gate are unlocked.
The factory setting (default setting) is set
as "non-operational".
For further details, we recommend that
you consult a SUBARU dealer.
! Power saving function
The keyless access function will be
disabled in the following cases to protect
the access key battery and the vehicle
battery.
– CONTINUED –
2-13