High/Low Beam Change (Dimmer); Headlight Flasher; Turn Signal Lever - Subaru FORESTER Manual

3-34
Instruments and controls
& High/low beam change (dim-
mer)
To change from low beam to high beam,
push the turn signal lever forward. When
the headlights are on high beam, the high
beam indicator light " " on the combina-
tion meter also illuminates.
To switch back to low beam, pull the lever
back to the detent position.
& Headlight flasher
To flash the headlights, pull the lever
toward you and then release it. The high
beam will stay on for as long as you hold
the lever. The headlight flasher works
even though the light switch is in the
"OFF" position.
When the headlights are on high beam,
the high beam indicator light "
combination meter also illuminates.
CAUTION
Do not hold the lever in the flashing
position for more than just a few
seconds.

Turn signal lever

To activate the right turn signal, push the
turn signal lever up. To activate the left
turn signal, push the turn signal lever
down. When the turn is finished, the lever
will return automatically. If the lever does
not return after cornering, return the lever
to the neutral position by hand.
" on the
To signal a lane change, push the turn
signal lever up or down slightly and hold it
during the lane change. The turn signal
indicator lights will flash in the direction of
the turn or lane change. The lever will
return automatically to the neutral position
when you release it.