Power Test - CyberData 011394 Quick Start Manual

3.0 Power Test

3.1. Plug in the CyberData device and monitor the LED activity on the front of
the device. See the following figure:
3.2. The GREEN
immediately. The
After about 27 seconds, the
indicate that the board is fully booted.
If there is no DHCP server available on the network, it will try 12 times with a
three second delay between tries and eventually fall back to the
programmed static IP address (by default 10.10.10.10). This process will
take approximately 80 seconds.
3.3. When the device has completed the initialization process, press and hold
the RTFM switch for 3 seconds to announce the IP address.
This concludes the power test. Go to
in a Test
Quick Start Guide
VoIPon www.voipon.co.uk sales@voipon.co.uk Tel: (0)330 088 0195 Fax: +44 (0)1245 808299
power/status LED and the
YELLOW
Environment".
YELLOW
network LED will blink to indicate network traffic.
GREEN power/status LED will blink twice to
Section 4.0, "Connecting to a Network
Network
Link/Activity
(Yellow LED)
Speaker
Status
(Green LED)
network LED come on
931182A