Menu - Emerson Powerdrive F300 Getting Started Manual

For new parameter-values to apply after the AC supply to the drive is interrupted, new
NOTE
values must be saved. Refer to section 5.7 Saving parameters on page 52.
5.3

Menu 0

Menu 0 is used to bring together various commonly used parameters for basic easy set up of the
drive. Appropriate parameters are copied from the advanced menus into menu 0 and thus exist in
both locations. For further information, refer to Chapter 6 Basic parameters (Menu 0) on page 54.
5.4 Menu structure
The drive parameter structure consists of menus and parameters. The drive initially powers up so
that only Menu 0 can be viewed. The up and down arrow buttons are used to navigate between
parameters and once Pr 00.049 has been set to 'All Menus' the left and right buttons are used to
navigate between menus. For further information, refer to section 5.11 Parameter access level and
security on page 53.
Figure 5-4 Menu structure
Menu 0
....MM.000....
00.050
00.049
00.048
00.047
00.046
00.005
00.004
00.003
00.002
00.001
Moves between Menus
50
The menus and parameters roll over in both
directions. i.e. if the last parameter is
displayed, a further press will cause the
display to rollover and show the first
parameter.
When changing between menus the drive
remembers which parameter was last
viewed in a particular menu and thus
displays that parameter.
Moves
between
parameters
* The option module menus (S.mm.ppp) are
only displayed if option modules are
installed. Where S signifies the option
module slot number and the mm.ppp
signifies the menu and the parameter
number of the option module's internal
menus and parameter.
Powerdrive F300 Getting Started Guide
Issue Number: 5