Transferring Data - Emerson Powerdrive F300 Getting Started Manual

9.3

Transferring data

Data transfer, erasing and protecting the information is performed by entering a code in Pr mm.000
and then resetting the drive as shown in Table 9-1.
Table 9-1 SMARTCARD and SD card codes
Code
Transfer the drive parameters to parameter file 001 and
2001 sets the block as bootable. This will include the parameters
from attached option modules.
Transfer the drive parameters to parameter file yyy. This
4yyy
will include the parameters from attached option modules.
Transfer the onboard user program to onboard user
5yyy
program file yyy.
Load the drive parameters from parameter file yyy or the
6yyy
onboard user program from onboard user program file yyy.
7yyy Erase file yyy.
Compare the data in the drive with file yyy. If the files are
the same then Pr mm.000 (mm.000) is simply reset to 0
8yyy when the compare is complete. If the files are different a
'Card Compare' trip is initiated. All other NV media card
trips also apply.
9555 Clear the warning suppression flag
9666 Set the warning suppression flag
9777 Clear the read-only flag
9888 Set the read-only flag
9999 Erase and format the NV media card
Backup all drive data (parameter differences from defaults,
an onboard user program, applications programs and
miscellaneous option data), including the drive name; the
40yyy store will occur to the </MCDF/driveyyy/> folder; if it does
not exist, it will be created. Because the name is stored, this
is a backup, rather than a clone. The command code will be
cleared when all drive and option data have been saved.
Load all drive data (parameter differences from defaults, an
onboard user program, applications programs and
miscellaneous option data); the load will come from the
60yyy
</MCDF/driveyyy/> folder. The command code will not be
cleared until the drive and all option data have been
loaded.
Powerdrive F300 Getting Started Guide
Issue Number: 5
Operation SMARTCARD SD card
103