The Static Dhcp Screen - ZyXEL Communications SBG5500-A User Manual

6.4 The Static DHCP Screen

This table allows you to assign IP addresses on the LAN to specific individual computers based on their
MAC Addresses.
Every Ethernet device has a unique MAC (Media Access Control) address. The MAC address is assigned
at the factory and consists of six pairs of hexadecimal characters, for example, 00:A0:C5:00:00:02.
Use this screen to change your SBG's static DHCP settings. Click Configuration > LAN / Home Network >
Static DHCP to open the following screen.
Figure 64 Configuration > LAN / Home Network > Static DHCP
The following table describes the labels in this screen.
Table 24 Network Setting > LAN > Static DHCP
LABEL
Add
Edit
Remove
Multiple Entries Turn
On
Multiple Entries Turn
Off
#
Status
MAC Address
IP Address
6.4.1 Edit Static DHCP
If you click Add in the Static DHCP screen or Edit next to a static DHCP entry, the following screen
displays.
Chapter 6 LAN
DESCRIPTION
Click this to add a new static DHCP entry.
Click Edit to configure a static DHCP entry.
Click Remove to delete a static DHCP entry.
Select one or more static DHCP entry and click this to enable them.
Select one or more static DHCP entry and click this to disable them.
This is the index number of the DHCP entry.
This field displays whether the entry is active.
Click the slide button to turn on or turn off the entry.
This field displays the MAC address of a computer on the LAN.
This field displays the IP address relative to the MAC address field listed above.
SBG5500 Series User's Guide
94