Edit Default Server - ZyXEL Communications SBG5500-A User Manual

The following table describes the labels in this screen.
Table 48 Configuration > NAT > Default Server
LABEL
Edit
#
WAN Interface
Default Server Address

8.5.1 Edit Default Server

This screen lets you edit interface groups. Select an interface and click Edit to open the following screen.
Figure 103 Default Server: Edit
The following table describes the fields in this screen.
Table 49 Default Server: Edit
LABEL
WAN Interface
Default Server
Address
OK
Cancel
Chapter 8 Network Address Translation (NAT)
DESCRIPTION
Double-click an entry or select it and click Edit to open a screen where you can modify
the default server's IP address.
This is the index number of the WAN interface.
This shows the name of the interface group that was created in the Configuration > LAN
/ Home Network > VLAN / Interface Group screen.
This shows the IP address of the default server.
DESCRIPTION
This shows the name of the interface group that was created in the Configuration > LAN / Home
Network > VLAN / Interface Group screen. The host must be in the same VLAN as the selected
VLAN / Interface Group.
Enter the IP address of the default server which receives packets from ports that are not
specified in the NAT Port Forwarding screen.
Note: If you do not assign a Default Server Address, the SBG discards all packets
received for ports that are not specified in the NAT Port Forwarding screen.
Click OK to save your changes.
Click Cancel to restore your previously saved settings.
SBG5500 Series User's Guide
132