Table of Contents
Advertisement
Figure 51 WAN / Internet > WAN Setup > Add/Edit: Bridge Mode (ADSL over ATM)
The following table describes the fields in this screen.
Table 12 WAN / Internet > WAN Setup > Add/Edit: Bridge Mode (ADSL over ATM)
LABEL
DESCRIPTION
General
Interface Enable Select this to activate the WAN configuration settings.
Name
Enter a service name of the connection.
Type
Select ADSL over ATM as the interface for which you want to configure here. The SBG uses the
ADSL technology for data transmission over the DSL port.
Mode
Select Bridge when your ISP provides you more than one IP address and you want the
connected computers to get individual IP address from ISP's DHCP server directly. If you select
Bridge, you cannot use routing functions, such as QoS, Firewall, DHCP server and NAT on traffic
from the selected LAN port(s).
ATM PVC Configuration (These fields appear when the Type is set to ADSL over ATM.)
VPI
The valid range for the VPI is 0 to 255. Enter the VPI assigned to you.
VCI
The valid range for the VCI is 32 to 65535 (0 to 31 is reserved for local management of ATM
traffic). Enter the VCI assigned to you.
Chapter 5 WAN/Internet
SBG5500 Series User's Guide
65
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
