Edit Remote Server Log Settings - ZyXEL Communications SBG5500-A User Manual

Table 100 Configuration > Log / Report > Log Settings > Edit (System and Email)
LABEL
E-mail Server
#
Log Category
System Log
E-mail Server
OK
Cancel

13.3.3 Edit Remote Server Log Settings

The Log Settings Edit screen controls the detailed settings for each log in the remote server (syslog). Go
to the Log Settings screen
Chapter 13 Log / Report
DESCRIPTION
Use the E-Mail Server drop-down list to change the settings for e-mailing logs to e-
mail server for all log categories.
Using the System Log drop-down list to disable all logs overrides your e-mail server
settings.
enable normal logs (green check mark) - e-mail log messages for all categories to e-
mail server.
enable alert logs (red exclamation point) - e-mail alerts for all categories to e-mail
server.
This field is a sequential value, and it is not associated with a specific address.
This field displays each category of messages. It is the same value used in the Display
and Category fields in the Log Viewer tab. The Default category includes debugging
messages generated by open source software.
Select which events you want to log by Log Category. There are three choices:
disable all logs (red X) - do not log any information from this category
enable normal logs (green check mark) - create log messages and alerts from this
category
enable normal logs and debug logs (yellow check mark) - create log messages,
alerts, and debugging information from this category; the SBG does not e-mail
debugging information, however, even if this setting is selected.
Select whether each category of events should be included in the log messages
when it is e-mailed (green check mark) and/or in alerts (red exclamation point) for
the e-mail settings specified in E-Mail Server. The SBG does not e-mail debugging
information, even if it is recorded in the System log.
Click this to save your changes and return to the previous screen.
Click this to return to the previous screen without saving your changes.
(Section 13.3 on page 217), select a remote server and click Edit.
SBG5500 Series User's Guide
222