Tangential Mode - GRAPHTEC FC5100-75 User Manual

• Select OTHER when above preset values and their deviation ranges cannot
• Select PEN to use a plotter pen.
• Select POUNCE to use the pouncing pen.
• Select LIGHT POINT to use the light pointer to check the cutter pass.
NOTE:
NOTE:
NOTE:
TANGENTIAL
mode
emulation mode to cover additional selection of media. For details see Tangen-
tial Emulation in Advanced Functions and Settings.
Cutter Condi-
• To change the setting of a group of conditions, press function keys [F1] through
tions
• Press the CONDITION key to access the condition menu.
• Press the NEXT key to cancel the condition where you are currently set and
NOTE:
T
• Press the F1 key to change FORCE. The blinking cursor indicates that you can
cover the range needed for satisfactory results.
These tool names are actually the names of preset offset values, and each
value can be changed within a range from -5 to +5.
The suffix "x" represents any cutter suffix within the family. For example, select
CB09Ux when using a CB09UA cutter.
When you select POUNCE, the cutter offset refers to the spacing between the
holes.
Press the ENTER key to select the desired tool.
Beside the cutter blade selection noted above, you can select the tangential
[F4] corresponding to the number of the group you wish to change. For example,
press the F1 key to select CONDITION 1. If the CONDITION 5 appears, then
press the F1 key again to select CONDITION 1.
return to the main menu.
If the TANGENTIAL EMULATION mode is enabled for the condition number
that you are currently working on, the overcut menu appears as soon as the
ENTER key is pressed. Change the values, if necessary. For details see Tan-
gential Emulation.
C C
O HANGE THE UTTER
change its setting.
SET............14.
CONDITION 1........30.
CB09Ux...0.
F
ORCE
SET............14
CONDITION 1........30
CB09Ux...0
P r ep a r in g t o Cu t : S et t in g Co n d it io n s
51
4.
4