Stand Assembly - GRAPHTEC FC5100-75 User Manual

Stand Assembly

assemble the Stand for the GRAPHTEC FC5100 Cutting Plotter. For best results,
follow all instructions carefully.
A
Tools provided with your Stand assembly.
1
2
The following information will give you step-by-step instructions on how to
A
SSEMBLY REA
Assemble the Stand on a secure, flat surface. You will be using the Hex Key
Lay one stand side horizontally and attach the right base assembly to stand
side with four (4) M5 x 16mm flanged socket head cap screws using the T-han-
dle hex key. Repeat this step with the other side.
Lay the middle bar horizontally and attach it to one stand side with two (2) M6
x 16mm socket buton head cap screws using the T-handle hex key. Repeat this
step with the other side.
Base assembly
Side assembly
Middle bar
Side stand assembly
O p ti on s : F C 51 00 S t an d M a n ua l
161