Roll-2 - GRAPHTEC FC5100-75 User Manual

48

ROLL-2

1
2
3
SHEET
1
2
3
4
5
6
CONTINUE
riage's current position. Set the various functions of the plotter as desired.
NOTE:
Pre pa rin g to C ut: In itia li zin g Ro u t in e
During initialization, the pen carriage moves right until it detects the mechani-
cal home position.
The pen carriage then moves left until it detects the left-hand side of the media
edge.
It then returns to the right edge of the media.
During initialization, the pen carriage moves right until it detects the mechani-
cal home position.
The pen carriage then moves left until it detects the left-hand side of the media
edge.
It then returns to the right edge of the media.
The media is fed backwards until the media's leading edge is detected.
The media is then fed forward until the media's trailing edge is found.
The media is fed backwards until the pen carriage locates the lower left posi-
tion of the cutting area.
CONTINUE does not perform initialization but begins plotting from the pen car-
Make sure to set the correct cutting conditions to suit the cutter blade and
media being used. For details see Setting Conditions.