Length Unit - GRAPHTEC FC5100-75 User Manual

• Press the F3 key to select 2mm BELOW or press the F4 key to select OUTSIDE.
• Press the ENTER key to register your setting and to proceed to the next menu.
key if you do not wish to make any changes. If you used METHOD 2 to select
BACKGROUND SETTINGS, turn off the plotter if you do not wish to make any
changes.

Length Unit

play panel to either units of millimeters or inches.
• Press the F3 key to select METRIC or press the F4 key to select INCH. A blink-
• Press the ENTER key to register your setting and to proceed to the next menu.
key if you do not wish to make any changes. If you used METHOD 2 to select
BACKGROUND SETTINGS, turn off the plotter if you do not wish to make any
changes.
A blinking cursor appears beside your choice.
INITIAL BLADE
CONTROL POSITION
Press the NEXT key if you wish to bypass this setting with no changes.
If you used METHOD 1 to select BACKGROUND SETTINGS, press the MENU
This selection enables you to set the unit for coordinates appearing on the dis-
ing cursor appears beside your choice.
Press the NEXT key if you wish to bypass this setting with no changes.
If you used METHOD 1 to select BACKGROUND SETTINGS, press the MENU
Ba ckg r o u n d S et t in g s: Ba ck gr ou n d S e tt i ng s f or HP -G L
2mm BELOW .
OUTSIDE .
LENGTH UNIT
METRIC .
INCH .
LENGTH UNIT
METRIC .
INCH .
PEN UP MOVE
ENABLED .
DISABLED .
119