Water Inlet Valve - Manitowoc SD0302A Technician's Handbook

Downloaded from www.Manualslib.com

Water Inlet Valve

The water inlet valve normally does not require
removal for cleaning. Refer to "Water System
Checklist" page 109, if you are troubleshooting water
related problems.
1. When the ice machine is off, the water inlet valve
must completely stop water flow into the machine.
Watch for water flow.
When the ice machine is on, the water inlet valve must
allow the proper water flow through it. Set the toggle
switch to ON. Watch for water flow into the ice
machine. If the water flow is slow or only trickles into
the ice machine, refer to water system checklist.
Disconnect the el ectric power to the ice machi ne
and dispenser at the electric service switch box and
turn off the water supply before proceeding.
Follow the procedure below to remove the water inlet
valve.
1. Remove the 1/4" hex head screws.
2. Remove, clean, and install the filter screen.
4 Hex Head
Screws
Part Number 80-1479-3 7/10
manuals search engine
Warning
!
53