Presetting Services - JVC Micro Component System UX-GB9DAB Instructions Manual

To scan for ensembles
With the ensemble scanning function, the System scans the
DAB bands to pick out available ensembles under your
receiving condition.
• When you change the source to DAB for the first time after
plugging in the AC power code, the System automatically
performs the scanning.
To perform the ensemble scanning manually
When you moved your System or adjusted the antenna
position, perform the scanning manually.
2 sec.
SET
ANT. P.
When the scanning is complete, the System starts playing the
first service of the lowest-frequency ensemble found.
To tune in to all the ensembles
You can tune in to every ensemble regardless of the signal
status.
PRESET/GROUP/PTY
DOWN UP
The frequency changes every second, going through all the
DAB ensembles.
Press and hold the button until the desired ensemble is
reached.
To improve DAB reception
With the supplied DAB antenna, you may not be able to
receive L-Band ensembles depending on your reception
condition. You can improve the reception of both L-Band
and Band III ensembles by connecting an active antenna (see
page 4) and supplying electricity to the antenna.
While on standby (Display ON)...
2 sec.
SET
ANT. P.
15
Remote
ONLY
12B 12C 12D
Remote
ONLY
ANT.P ON
ANT.P OFF
(Canceled)

Presetting Services

You can preset 30 services in memory.
1
Tune in to an ensemble, then select a service you want
to preset.
2
Activate the preset number entry mode.
SET
ANT. P.
S.TURBO
QP Link
3
Select a preset number for the service you store.
PRESET/GROUP/PTY
DOWN UP
Increases the
preset numbers.
Decreases the
preset numbers.
BAND
S.TURBO
QP Link
• You can only preset primary services. If you select a
secondary service to store, its primary service is stored
instead.
To tune in to a preset service
After selecting DAB as the source, select the preset number
for the preset station.
PRESET/GROUP/PTY
UP
DOWN
Increases the preset numbers.
Decreases the preset numbers.
Remote
ONLY
SET
ANT. P.
BAND
S.TURBO
QP Link