Advertisement
4
Carrier Installation – Split Draw Systems
S P L I T D R A W S Y S T E M S
The motor side of the drapery track requires four less carriers than the total number of hooks on the drapery track.
The first two drapery hooks should hook to the master carrier and the last two drapery hooks should hook to the motor
housing. The number of carriers required is different for the idle side. The idle side of the drapery requires three less
carriers than the total number of hooks on the drapery. The first two drapery hooks should hook to the master carrier,
and the last drapery hooks should hook onto the hook eye on the idle endcap. See diagram below.
2
Remove idle end cover
Idle end cover
retaining screw
Idle end hook eye
T O A D D O R R E M O V E C A R R I E R S :
Split Drive Systems
1
Follow the directions on page 6 for motor side plug
removal, and installation of the auxiliary carriers.
2
Remove screw that retains the idle end cover.
Remove idle and hook eye.
3
Insert or remove auxiliary carriers through the
square hole in the idler end cap until the proper
number of carriers are installed.
4
Install idle end hook eye and replace the idle end
cover using the screw removed in step 2.
Number of drapery
hooks minus three (3)
1
Remove track plug on the
motor side. Follow the directions
given on page 6.
4
2
Sivoia
Drapery
®
Number of drapery
hooks minus four (4)
3
7
Advertisement
