Advertisement
8
Infrared Control
M O U N T I N G T H E I R E Y E
Mount the IR eye to the wall, the ceiling or even a non-moving edge of the drapery fabric using a clip. Make sure
the location of the eye is not obstructed by an object.
The SV-IR allows the MDU to be controlled directly with a Sivoia Infrared Handheld Transmitter (SV-OCIT, SV-3PIT,
or SV-4GD-OCIT). The SV-IR receiver connects to the MDU via a 20 in (51cm) cable. This provides the SV-IR
receiver ample mounting range to offset any infrared signal restriction caused by a protective/decorative covering
for the shade system. To extend the IR receiver mounting range, add up to five (5) SV-IR-EXT-10 extension cables
(10 ft [3 m] each).
Note: To control an individual drapery with an IR transmitter, the SV-IR must be connected to that MDU. If there
is a Group/Subgroup of MDU's with the same Room/IR Address (see page 11), the SV-IR need only be con-
nected to one of those MDU's to control the entire Group/Subgroup.
• The SV-IR receiver must be located to allow line-of-sight reception of infrared signals.
• The IR transmitter has a range of 30 ft for the SV-IR to receive its signal.
• The SV-IR must NOT be located near lighting fixtures or in direct sunlight.
• The SV-IR must be located within 50 ft (15 m) of the MDU it is connected to. Add up to five SV-IR-EXT-10
extension cables (10 ft [3 m] each).
Connect the SV-IR
receiver to the wire
connector on the MDU
Sivoia
Drapery
®
13
Advertisement
