Table of Contents
Advertisement
1). Loosen the adjusting nut.
2). Adjust the pan direction [0° to 360°].
3). Adjust the tilt direction [0° to 90°].
4). Rotate the camera [0° to 360°] to adjust the lens to the
surveillance angle.
5). Tighten the adjusting nut to complete the installation.
2.3
Installation of Network Cable Water-proof
Jacket (Optional)
Purpose:
If the camera is installed outdoor, you can adapt the water-proof
accessory for the network cable after the camera is secured on the
installation surface.
① ②
Figure 2-6 Water-proof Accessory Components
No.
1
2
ST-IP4FB·Quick Start Guide
③
Table 2-1 Components
Components
Camera's Network Interface Socket
O-Type Gasket
20
④
⑤
⑥ ⑦
Advertisement
Table of Contents
