General Instructions On Programming - Festo SPC200 System Manual

7. Description of the commands
7.1

General instructions on programming

7−4
You must take the following into account when creating NC
programs:
the operating mode in which you intend to use the
SPC200.
In Start/Stop mode all NC commands are supported. In
Record Select mode only positioning commands, posi
tioning conditions and commands for setting the posi
tioning quality class are supported.
the number of fixed starting programs.
If a single or multi−axis system is controlled by an
SPC200, only one starting program is usually defined. If
two independent work stations are controlled, a separate
starting program must be defined for each work station
(autonomous operation of two work stations).
Festo P.BE−SPC200−EN en 0901d