Thanks - Naigon Electronic Spark Color SC2-R3 Setup Manual

The motion editor is an app that is used to adjust the motion parameters on the fly. Setting these values will
update the motion settings for every font of Spark Color 2™, as well as the sensitivity of this editing mode.
Once in the Motion Editor, press the main button to enter editing. From there the following actions are possible.
Entry Label
Aux Button AUX +/-
Aux Button AUX +/-
Swing saber NA
Rotate saber NA
Hit saber/Blade CS
Rotate saber NA
Swing saber NA
Hit saber/Blade NA
Main Button MAIN+/-
Main Button MAIN+/-
7.

THANKS

Special thanks to everyone that has supported me on this journey. It is the community support that makes this
worthwhile and gives me the passion to continue.
Godspeed, and MTFBWY!
Action Description
Press Increments the current motion parameter by 10.
Hold Plays the instructions.
Swing Plays the swing sound; swinging around the saber gets a feel
for the current motion settings.
Rotate Plays the Dual Phase™ sound (no color change). Performing
this motion gets a feel for the current settings.
Clash Plays the clash sound. Performing the clash gets a feel for the
current motion settings.
Rotate + Advances to the next motion parameter to edit. Parameters
Hold Aux are Swing Threshold, Slash Threshold, Clash Threshold, GyroX
Threshold, and GyroYX Threshold respectively.
Swing + Same behavior as rotating the saber and holding Aux; see
Hold Aux above.
Clash + Same behavior as rotating the saber and holding Aux; see
Hold Aux above.
Hold/Unlatch Holding or unlatching the main button will cause the
retraction sound to play and all changes made to this font will
be saved to disk. The saber will then enter the Saber
Configuration menu.
Hold/Unlatch If the aux is held when the main is held or unlatched, then the
+ hold Aux values will not be saved to disk, and the saber will enter the
button Saber Configuration menu.
Page | 32