Rumble Motor And Accessory Wiring - Naigon Electronic Spark Color SC2-R3 Setup Manual

Figure 5 – X4 wiring that uses four unique colors instead of doubling up on one color. This setup allows for more varied colors but is not as
intuitive to get correct color mixing. Also, while an RGBW was used only the RED die needed a resistor/diode; if an RGBA is used a second
resistor would be needed for the amber die as well.
4.4.

RUMBLE MOTOR AND ACCESSORY WIRING

When not using a fourth die the C4 pin can be use to run an accessory. For those familiar with the original Igniter™,
the C4 pin is actually a cross between the Crystal Pin and Flash- pin from Igniter™. Thus, it can be used for a single
crystal LED, a rumble motor, or any other accessory if not used as a fourth color.
The following diagram will show the use of a low power (3.3v) shaft-less motor that can be purchased from Pololu
here. If using something that required more voltage than 3.3v, the power could be drawn directly from the battery
instead of the VLED+ pin.
Page | 10