X-Saber Wiring - Naigon Electronic Spark Color SC2-R3 Setup Manual

Figure 7 – Wiring with an RGB crystal chamber. This will have an RGB led that matches the blade color and pulses with the blade. Note that
all three pins of the REB LED have a resistor since power is coming from the battery. I recommend a 22-33ohm for R1, and a 1ohm each for
R2.
4.6.

X-SABER WIRING

The following diagram shows the wiring of the XDrive and Spark Color 2™ board to utilize the X-Saber functionality.
Three NECree LEDs are shown; a TriCree can be used as well but resistors will be needed for all three red die.
Note that it is recommended to use a 26650 since the runtime drain for this setup is quite high.
Page | 12