Audio - Naigon Electronic Spark Color SC2-R3 Setup Manual

Figure 19 – Color set editing in the Spark Color 2™ Config Editor. Edit each color set from this tab, regardless of what font is currently loaded.

5.5.4. AUDIO

The audio tab has some settings related to the audio and audio related features.
NEW IN R3. The two checkboxes for LINEAR HUM/IN/OUT (LHUM) and LINEAR ACTION (LACT) can be selected
to force the files of the specified types to be loaded in order as they appear on disk instead of being sampled
randomly. Actions are defined as swing, slash, clash, lockup, and blast respectively.
HUMSTART sets the time when the hum will start mixing in with the outNN.wav sound, as a reverse offset in
milliseconds. For instance, if the outNN.wav being played is 2 seconds long and humStart is set to 500ms, then the
hum will start mixing in at 1500 milliseconds, which is 500ms before the end of the out wav sound. This allows for
a consistent experience with varying length out sounds.
The two volume settings are pretty straight-forward. Higher settings will make louder volumes. Recommended is
16 for effects and 15 for the hum. Setting to zero (0) will turn off that effect completely.
Page | 25