Blade Effects - Naigon Electronic Spark Color SC2-R3 Setup Manual

MBUTTON defines if the main button is either latching or momentary. If set to latching, do not enable SWAP
BUTTONS, as that is only supported for two momentary switches.
The SWAP BUTTONS setting is used to swap which buttons are main and aux. This is especially useful if the two
buttons are inside a control box, as it allows the top/bottom button to be whichever the user prefers. Think of this
as look inversion for console shooter games.
When USE BOOT SOUND is enabled, the default boot.wav from the root will be played. Disabling this setting will
boot with the first sound font's font.wav.
LOWPWR defines the length in seconds before the saber goes into Low Power mode, which is where the accent
LEDs shut off and the motion for the menu is disabled. Handy for cons as it saves a lot of power when hanging on
the belt since the accents drain a lot of power.

5.5.2. BLADE EFFECTS

The blade effects tabs contain settings for the blade's pulsing scheme, along with the settings for the extension
and retraction effects.
For Spark Color 2™, the blade effects for the main blade and clash are both set with a simple dropdown. Simply
select the desired effect from one of the pre-defined choices. The blade offers different types from static to subtle
flickering to deeper flickering, along with a few different pulses as well.
NEW IN R3. – ALTERNATING CLASH (ACLSH) can be enabled to use the more dramatic clash where the low color
is sampled from the blade color instead of the low clash color. This allows for the clash to overlay over the main
blade color.
Page | 23