Single Color Cross-Guard Blade - Naigon Electronic Spark Color SC2-R3 Setup Manual

Figure 8 – Wiring with the XDrive for the X-Saber feature. If TriCrees are used then 3 resistors/STTH2L06's would be needed for the red die.
After wiring this feature, not only does X-Saber need to be enabled in the master config, but also c4Percent should
be set to 95, and then for each colorset where it is desired to have the side LEDs engaged the color should be set
to a non-zero value. I recommend 100 as the side LEDs are short and running 3 high-power LEDs causes a large
drain on the batteries. So for color set 1, the following would work: C4COLOR=100, C4FLSH=100, C4BLST=100.
If you want to do something more advanced like having a color set where the side blades only come on during the
clash effect, you could set the following: C4COLOR=0, C4FLSH=100, C4BLST=0. This allows each font to have a
different cross-guard setup.
4.7.

SINGLE COLOR CROSS-GUARD BLADE

If you want to run a single color blade with the cross-guard functionality, then the following diagram for Spark 2™'s
Cross-Saber will work.
Page | 13