Full Wiring With Accents - Naigon Electronic Spark Color SC2-R3 Setup Manual

Figure 10 - Wiring a triangular prism style WS2812 blade with 3 parallel strips. It is also possible to do two strips back to back, though that
increases the vertical shadowing and doesn't look as good when looking right at the seams. Notice that there is an extra ground wire from
the TruDrive to the main ground; this is recommended to ensure adequate amperage can flow to the string.
4.9.

FULL WIRING WITH ACCENTS

The following diagram shows how to wire all accent LEDs and the recharge port, which will utilize every feature of
Spark Color 2™ (except for C4-). This will be the typical diagram for most folks that are looking for a build that
utilizes all the great features of the board without overly complicated wiring. Note that the accent pads 4-8 are in
the middle of the bottom of the board and require 28-30 gauge wire and surface type soldering (strip a small bit of
insulation from a solid core wire and push it through the accent LED hole from the top side and apply solder on the
top of the pad on the bottom side to seal).
Page | 15