Saber Tracks - Naigon Electronic Spark Color SC2-R3 Setup Manual

Entry Label
Aux Button AUX +/-
Aux Button AUX +/-
Aux Button AUX +/-
Swing saber NA
Rotate saber NA
Hit saber/Blade CS
Main Button MAIN+/-
6.3.

SABER TRACKS™

Saber Tracks™ is the special seventh (7
track02.wav, ..., trackNN.wav, in the
effect and start playing the tracks.
6.3.1. SABER TRACKS INTERACTIVITY
The following table describes the interactivity for Saber Tracks.
Entry Label
Aux Button AUX +/-
Main Button MAIN +/-
Main Button MAIN +/-
Aux Button AUX +/-
6.4. SABER CONFIGURATION
Action Description
Press Pressing the aux button engages Blaster Block mode. Once in
this mode, swinging the saber will perform EzBlaster™, where
another Blaster Block will be performed. Keeping the saber
still will cause the mode to exit.
Hold Holding the aux button is the second way to engage the
Lockup effect; the primary way is by EzLockup™ - tapping the
aux once after performing a Clash. Depending on the chosen
config setting, either releasing the button or tapping it again
will cause the mode to exit.
Press (in Pressing the AUX button will perform EzClash™; immediately
Clash) after the press the Lockup sound will play when in Clash
mode. This is the preferred way to perform a clash on
Igniter™.
Swing Swinging the saber causes a single swing sound to be played.
If the swing is performed rapidly then a Slash sound will be
performed.
Rotate Rotating the saber will advance the color set to the next
color, loading in the new blade, clash and blast colors.
Clash Hitting the saber against something or hitting your hand on
the hilt will cause the Clash sound to play. To return to
running simply wait for the clash to finish.
Hold/Unlatch Holding or unlatching the main button will cause the
retraction sound to play and then the saber will return to Idle
mode.
th
) font of Spark Color 2™ that can play the track files. Place track01.wav,
/TRACKS FOLDER, and then engaging this font will immediately load into the
Action Description
Press Advances to the next track. When the last track file is reached
it goes back to the beginning.
Hold/Latch Holding or latching the main button will enable the blade,
doing the extension effect first then the pulse effect.
Hold/Unlatch Holding or unlatching the main button will cause the blade to
retract if the blade is current enabled.
Hold Holding the aux button will exit Saber Tracks™ and load the
first font.
Page | 30